Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZCG91246
Summary of Contents for Zanussi ZCG91246
- Page 1 User Manual Cooker ZCG91246...
-
Page 2: Table Of Contents
Cleaning and user maintenance shall not be made by children • without supervision. General Safety Only a qualified person must install this appliance and replace • the cable. Do not operate the appliance by means of an external timer or • separate remote-control system. www.zanussi.com... -
Page 3: Safety Instructions
Always wear door or the window is opened. safety gloves. • Do not pull the appliance by the handle. • The kitchen cabinet and the recess must have suitable dimensions. www.zanussi.com... - Page 4 • This appliance is not connected to a device, – do not put water directly into the hot which evacuates the products of appliance. combustion. Make sure to connect the www.zanussi.com...
- Page 5 • Keep children away when the grill is in use. Authorised Service Centre. • Do not put the oven shelf with food on the • Be careful when you remove the door from highest shelf level. the appliance. The door is heavy! www.zanussi.com...
-
Page 6: Cooker Specification
Hob integrated ignition on the control knob Hob ignition on the spark generator button Oven integrated ignition on the control knob Oven ignition on the spark generator button Hob thermocouple Oven thermocouple Oven cleaning Enamel Catalytic Pan support Enamel Cast iron www.zanussi.com... -
Page 7: General Overview
• Coffee pot (if applicable) For roasting larger joints of meat and poultry. For coffee makers and small pans. • Storage compartment The storage compartment is below the oven cavity. To use the compartment, lift the lower front door then pull it down. www.zanussi.com... -
Page 8: Before First Use
• For all hobs without thermocouple first turn the knob and then push the knob down. Release knob when the burner lights. • For integrated ignition on knob push the knob for the hob down and turn it counterclockwise to the maximum gas flow position www.zanussi.com... -
Page 9: Hob - Hints And Tips
Do not put unstable or damaged pots on the burners to prevent from spill and injury. Cookware CAUTION! WARNING! Make sure that pot handles are not Do not put the same pan on two burners. above the front edge of the cooktop. www.zanussi.com... -
Page 10: Hob - Care And Cleaning
Cleaning the spark plug Speak to your local Authorised Service Centre periodically to check the conditions of the gas This feature is obtained through a ceramic supply pipe and the pressure adjuster, if fitted. ignition candle with a metal electrode. Keep www.zanussi.com... -
Page 11: Oven - Daily Use
Keep the knob for the oven functions pushed for 15 seconds or less to let the thermocouple warm up. If not, the gas flow is interrupted. Manual ignition of oven gas burner www.zanussi.com... -
Page 12: Oven - Using The Accessories
The food Wire shelf: may be burnt, especially in the rear part of the tray. Put the shelf on the correct shelf position. Make sure it does not touch the back wall of the oven. www.zanussi.com... - Page 13 2. Put the turnspit handle into the spit. pan from the oven. 3. Put the baking tray on the lowest shelf level. 4. Snap out one end of the support hook from the oven ceiling A and let it hang on the other end. www.zanussi.com...
-
Page 14: Oven - Hints And Tips
Find the best settings (heat setting, same. cooking time, etc.) for your cookware, recipes • You can extend baking times by 10 – 15 and quantities when you use this appliance. minutes if you bake cakes on more than one shelf position. www.zanussi.com... - Page 15 5 - 10 100 - 120 Rabbit 2.0 - 3.0 80 - 90 min. 5 - 10 90 - 110 Beef 2.4 - 3.0 90 - min. 5 - 10 100 - 120 1) Turn oven after 45 min. www.zanussi.com...
- Page 16 45 - 55 Yeast cake 1) Preheat the oven for 15 minutes. Grilling Food Quantity (kg) Grill position Time (min) Shelf position 1.5 - 2.5 half 20 - 25 Sheep chops 2.0 - 2.5 half 45 - 60 Ribs www.zanussi.com...
-
Page 17: Oven - Care And Cleaning
2. Lift and turn the levers on the two hinges. sponge only. Dry it with a soft cloth. Do not use steel wool, acids or abrasive materials as they can damage the oven surface. Clean the oven control panel with the same precautions. www.zanussi.com... -
Page 18: Troubleshooting
2. Clean the glass cover. the top edge of the door. Lift the inner door. 3. Replace the lamp with a suitable 300 °C heat-resistant lamp. 4. Install the glass cover. Troubleshooting WARNING! Refer to Safety chapters. www.zanussi.com... - Page 19 The rating plate is on the front If you cannot find a solution to the problem frame of the appliance cavity. Do not remove yourself, contact your dealer or an Authorised the rating plate from the appliance cavity. Service Centre. www.zanussi.com...
-
Page 20: Installation
Technical data For minimal distances for fitting check the table. Dimension Height 850 - 870 Width Depth Appliance class Other technical data Appliance category: II2H3B/P LPG: G30 (3B/P) 28-30 mbar Natural Gas: G20 (2H) 20 mbar www.zanussi.com... - Page 21 You can connect the gas supply to either one of pipes, make sure they do not come in touch them. The pipe that is not used must be with mobile parts and they are not squeezed. clogged with the pipe closer, which added to the appliance. www.zanussi.com...
- Page 22 To check the seal use a soap solution, not a flame. 4. Replace injectors with the ones necessary for the type of gas you use. The gas supply ramp is on the rear side of the control panel. www.zanussi.com...
- Page 23 1. Fully tighten the bypass screw. 2. Put the knob back. Changing from liquid gas to natural gas 1. Unscrew approximately one turn the bypass screw position A. 2. Put the knob for the hob back. 3. Connect the appliance to the electricity. www.zanussi.com...
- Page 24 4. Release the burner injector with a 7 mm socket spanner and replace it with a right one. Changing from natural gas to liquid gas 1. Fully tighten the bypass screw. 2. Put the knob back. 3. Connect the appliance to the electricity. www.zanussi.com...
- Page 25 2. Put the appliance on the sidewall on a clean and smooth surface. Place each foot into a 2. Release the burner injector with a 7 mm separate hole, in the plinth, and rotate it socket spanner and replace it with a right counterclockwise. one. www.zanussi.com...
- Page 26 Return the product to your the packaging in applicable containers to local recycling facility or contact your municipal recycle it. Help protect the environment and office. human health and to recycle waste of electrical and electronic appliances. Do not dispose www.zanussi.com...
- Page 27 www.zanussi.com...
- Page 28 www.zanussi.com/shop...