Battery; To Insert The Battery; To Charge The Battery Using The Charger - NEC 338 Product Manual

Battery

To Insert the Battery

1
When fitting the battery, face the outside cover of the battery towards you. Place the top of the battery into position and
push the lower section of the battery into place.
You can charge the battery whenever you wish without affecting the performance of the phone.
Your 338 automatically switches off if the battery charge is too low.
Batteries have a life cycle. If you find that the amount of times you have to charge the battery is increasing dramatically,
the battery life may be coming to an end. Use only the NEC original or approved batteries. Unapproved batteries can
impair the performance of the phone and invalidate the warranty.
When the battery is not being used for a long period of time, remove it from your 338 and store in a cool, dry place.
A battery that has not been used for a long period of time needs to be completely discharged and then recharged two or
three times before reaching full capacity.
Charging

To Charge the Battery Using the Charger

1
Insert the battery into the phone (see To Insert the Battery section above).
2
Connect the charger plug to your 338 I/O connector (see the diagram on the next page).
3
Plug the charger into a mains socket. The LED indicator on your 338 lights up while charging is in progress and goes
off when charging is completed.
4
After charging is completed, unplug the charger from the I/O connector.
Setting up your 338
-6-