Honda HSS622 Owner's Manual page 34

• To minimize the possibility of potentially dangerous electrical shocks,
always use a 3-conductor power cord with a power rating of no less
than 15 amps. Also, be sure that the outlet you are using is properly
grounded.
• Do not connect and disconnect the power cord with wet hands.
• Be sure to hold the plug when disconnecting the power cord from the
electrical outlet or switch box. Do not disconnect by pulling on the
power cord.
5.Push the starter button until the engine starts.
CAUTION:
• Do not operate the starter for more than 1 minute. If the engine fails
to start, release the button and allow the starter to cool for 15
minutes before operating it again.
• To avoid serious engine damage, never operate the starter while the
engine is running.
• After the engine starts, disconnect the power cord from the electrical
outlet first, and then from the switch box.
STARTER BUTTON
[MANUAL STARTING ONLY]
6.Pull the starter grip lightly until you feel resistance, then pull briskly
in the direction of the arrow as shown below.
CAUTION:
• Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
• Damage may result if the starter grip is pulled while the engine is
running.
PUSH
STARTER GRIP
Direction to pull
31