sparkfun ZED-F9P Hook-Up Manual page 20

If you have not already, make sure to check out the Getting Started with MicroMod: Hardware Hookup for
information on inserting your Processor Board to your Carrier Board. Just insert the MicroMod Processor Board at
an angle of about 25° into the M.2 socket, push down, and secure with the screw.
Getting Started with MicroMod
OCTOBER 21, 2020
Dive into the world of MicroMod - a compact interface to connect a
microcontroller to various peripherals via the M.2 Connector!
At a minimum, your setup should look like the image below. In this case, we had the MicroMod ESP32 Processor
Board secured in the M.2 connector.
GNSS Multi-band Antenna
As stated earlier, you'll need a multi-band antenna and a metal ground plate to make the best use of the ZED-F9P.
Connect the two SMA connectors together and tighten the nut. You'll simply need the nut to be finger tight.