Record On Md; Record - Sony MDS-S500 Instruction Manual

Machine Translated by Google

Record on MD

Record

When recording to an MD that has already been recorded, it
will automatically record the continuation of the recorded part.
`/1
INPUT
1 Turn on the sound source you want to record
and the power source of the system
stereo (or amplifier).
2 Select a sound source with system
stereo (or amp)
3 Press the? / 1 (power) switch on
this unit to turn on the power .
The STANDBY lamp turns off.
4 Insert MD for recording
5 Press INPUT repeatedly to select the sound source you
want to record. Select the terminal to which the
sound source is connected . Display Digital optical
input D-IN Analog input
6 Press z
It will be in the recording standby state.
slot
NX z
A-IN
7 Adjust the recording level as needed
For more information, see
"Adjusting the recording level" (page
19).
8 Press N or X, then start playing the
sound source you want to record.
Basic operation during
recording Operation in such a case
Stop recording Press x. Pause recording
Press X. Press it again to resume recording.
Take out the MD After stopping the recording
If you pause the recording and then resume it, the song
number will change. For example, if you pause recording
while recording the 4th song, it will be the 5th song from the
time you resume recording.
To prevent erroneous recording
erasure If you move the MD erroneous erasure
prevention knob to open a hole, you will not be able to
record. Once you close the hole, you will be able to record again.
Accidental erasure prevention knob
Make a hole
z You can immediately play back the recorded song and
check it. Immediately after stopping recording, press N.
Playback starts from the first song recorded this time.
Press A.
Continue to the next page
13