Table of Contents
Advertisement
Wiring Diagram
RGB Signal cable (supplied)
To mini D-Sub 15-pin connector on the projector. It is
recommended that you use a commercially available
distribution amplifier if connecting a signal cable longer
than the supplied cable.
VCR, DVD Player or
LaserDisc Player
Document Camera
NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC
before turning on the power to the notebook PC. In most cases signal cannot be output from RGB output
unless the notebook PC is turned on after connecting with the projector.
NOTE:
* If the screen goes blank while using your remote control, it may be the result of the computer's screen-
saver or power management software.
* If you accidentally hit the POWER button on the remote control, wait 90 seconds and then press the
POWER button again to resume.
NOTE: If using video, S-video, or audio cables, the cables should be 3 m (9.8 feet) or shorter.
To video, S-video, and audio
inputs on the projector.
PC CONTROL
AUDIO
VIDEO
Component V cable RCA 3 (not supplied)
or Optional 15-pin-to-RCA (female) 3 cable
(ADP-CV1)
S-VIDEO
RGB
E-18
Macintosh
(Desktop type or notebook type)
IBM VGA or Compatibles
(Desktop type or notebook type)
DVD Player
(with component output)
Advertisement
Table of Contents
