Table of Contents
Advertisement
1.
Remove the battery: press the battery release latch in and at the same time pull the battery pack off.
2.
To insert the battery, push the battery pack onto the contacts of the tool.
6.2 OPERATING MODES
➢
Remove the battery before carrying out any work on the power tool.
Setting the cutting depth (see figure C)
➢
Adapt the cutting depth to the thickness of the workpiece. A space of less than the height of one full
tooth should be visible under the workpiece.
Loosen the clamping lever. For a smaller cutting depth, pull the saw away from the base plate; for a larger
cutting depth, push the saw towards the base plate. Adjust the desired cutting depth at the cutting-depth
scale. Re- tighten the clamping lever.
The clamping force of the clamping lever can be readjusted. To do so, unscrew the clamping lever and
retighten it in a position offset by at least 30° in an anticlock- wise direction.
Setting the mitrelbevel angle
We recommend that you place the power tool down on the front side of the protective guard. Loosen the
wing bolt. Swivel the saw to the side. Set the required mitre angle on the scale retighten the wing bolt.
Note: When making mitre cuts, the cutting depth is less than the value shown on the cutting depth scale.
Cut marks
The 0° cut mark indicates the position of the saw blade when making a right-angled cut.
The 45° cut mark indicates the position of the saw blade when making a 45° cut.
Start-up
Inserting the battery
➢
Use only original lithium-ion batteries with the voltage stated on the type plate of your power
tool. Using other batteries can lead to injuries and pose a fire hazard.
Slide the charged battery into the foot of the power tool from the front. Press the battery fully into the foot
until the red stripe is no longer visible and the battery is securely locked.
Switching on/off
To start the power tool, first press the lock-off switch then press and hold the on/off switch.
To switch off the power tool, release the on/off switch.
Note: For safety reasons, the on/off switch cannot be locked; it must remain pressed during the entire
operation.
Protection Against Deep Discharging
The lithium-ion battery is protected against deep discharge by the Electronic Cell Protection (ECP). When
the battery is discharged, the power tool is switched off by means of a protective circuit: The application tool
no longer rotates.
Practical advice
The width of cut varies depending on the saw blade used. Protect saw blades against shock and impact.
Guide the power tool evenly, pushing it gently in the cutting direction. Applying too much pressure to the
power tool when moving it in the cutting direction significantly reduces the service life of the application tools
and can damage the power tool.
The sawing performance and the quality of the cut essentially depend on the condition and the tooth shape
of the saw blade. This is why you should only use sharp saw blades that are suitable for the material being
machined.
14
Advertisement
Table of Contents
