Husqvarna R 318X Operator's Manual page 100

Hide thumbs Also See for R 318X:
Table of Contents

Advertisement

Available languages

Available languages

3. TRANSMISSION, CONTROLS AND DRIVE SYSTEM
Do a check of the oil in the transmission and fill if it is necessary. Refer to
a check of the transmission oil level on page 109 .
Examine and adjust the parking brake.
Replace the oil in the transmission. Refer to
oil level on page 109 .
4. CUTTING EQUIPMENT
Clean the outer and inner surfaces of the cutting deck and the cutting deck
covers.
Do a check of and adjust the cutting height and pitch setting.
Examine the blades in the cutting deck, sharp and balance if needed.
5. LAST INSPECTION AND DOCUMENTATION
Do a check of and adjust the engine RPM.
Make sure that the product does not move in neutral position.
Do a check of the forward drive and the rearward drive on different speeds.
Do a check of the blade engagement, seat, lift and forward drive/brake. Refer to
Safety devices on the product on page 90 .
Do an inspection of the collection system (if applicable).
To clean the product
CAUTION:
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around the
100
To do a check of the transmission
Do not use a high-pressure
First
servicing
To do
First
servicing
First
servicing
transmission, the transmission air intake, and the
engine.
Use running water from a hose to clean the product.
Do not use high pressure.
Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
To clean the cutting deck, put it in the servicing
position and clean it with a water hose.
Maintenance interval
in hours
50
100
200
O
O
O
O
Maintenance interval
in hours
50
100
200
O
O
O
O
O
Maintenance interval
in hours
50
100
200
O
O
O
O
O
O
O
O
O
O
838 - 010 - 15.03.2022
O

Advertisement

Table of Contents
loading

This manual is also suitable for:

R 320x awd

Table of Contents