Lubrication And Drainage - JUKI MO-6800S Series Instruction Manual

4. LUBRICATION AND DRAINAGE

WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
(1) Lubrication oil
❷
1) Remove oil sight window ❶
at a super-high speed (JUKI MACHINE OIL #18) supplied with the unit or equivalent through the oil inlet.
When the oil surface reaches the space between two marker lines on the oil gauge, tighten oil sight window ❶.
not been used for an extended period of time, the shaded sections of needle bar ❷ and upper looper guide
❸ have to be lubricated.
(2) Drainage and re ll the oil
❶
TRIAL MODE − a valid license will remove this message. See the keywords property of this PDF for more information.
❸
1) Loosen the screw ❶ and drain all the oil inside the
oil tank. Then, tighten the screw ❶ again.
2) In order to extend the term of usage, please replace
it every four months.
– 6 –
❶