Magtek cDynamo Quick Installation Manual

cDynamo makes mobile payments and card reading easier than ever. The
form fitted enclosure is perfect for high traffic merchants, in-flight sales, line-
busting, and pay-at-the-table service. cDynamo delivers an integrated secure
card reader authenticator for magstripe cards with a long smooth swipe
path for excellent first swipe read rates
Major Components
Front
Lightning™ connector
MagneSafe® secure card reader authenticator (SCRA)
Bottom enclosure
Quick Installation Guide
Setup and Installation
Back
micro-USB port
Top enclosure
1
3
2
MagTek Inc., 1710 Apollo Court, Seal Beach CA 90740 | p 562-546-6400 | support 562-546-6800 | f 562-546-6301 | www.magtek.com
®
Secure Card Reader Authenticator
Connection
Connect the Top and Bottom Enclosures cDynamo SCRA
enclosure is made up of two pieces that easily snap together
around the iPad. Place the iPad device inside the top enclosure.
Be sure the iPad slides to the top and snaps in place.
Slide the bottom enclosure into place by lining up the Lightning
connector on cDynamo and the Lightning port of your iPad device.
Sections 1 and 3 shown in the diagram should snap in place to the inside of
the enclosure, and section 2 should snap to the outside of the enclosure.
When removing the iPad from the top enclosure, pull both sides out
so the case is pushed past the buttons on your iPad device.
USB cable micro-USB cable. Part Number (PN) 1000002547
RIGHT ANGLE MICRO USB B PLUG
Power
cDynamo is powered through the iOS device. It only uses power during a
transaction. To charge your iOS device while cDynamo is attached, connect
the optional micro-USB cable (micro-B) to the back of cDynamo, and then
connect the opposite end (USB-A) to the appropriate Apple charging adapter.
Connection - USB Port
Plug the micro-USB connection end of the cable into cDynamo's micro-
USB port, then attach the USB connection to your Apple charging adapter.
Pass-through micro-USB port allows the iPad device to charge without
disconnecting cDynamo.
Connection - Lightning
Lightning connector supports charge ONLY; iTunes
synchronization is not available.
Mounting
VESA Mount = MIS-D 4"x 4" (100mm x 100mm), Qty 4 - M4 screw threads.
MagTek®, MagnePrint®, and MagneSafe® are registered trademarks of MagTek, Inc.
MAGTEK: Registered to ISO 9001:2015 © Copyright 2022 MagTek, Inc. PN D998200074 rev 50 10/22
cDynamo
made for iPad
USB A PLUG