Light Sensor - MDT SCN-DTSEN1.01 Technical Manual

Technical Manual
Twilight-/Temperature Sensor KNX [SCN-DTSEN1.01]

4.2 Light sensor

The following settings are available for this menu:
Figure 4: Settings – Light sensor
The following table shows the possible settings:
ETS-Text
Send measured value
Send on change of ...
Send cyclically
every ...
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1 • Germany
8
Phone: +49-2263-880 • knx@mdt.de • www.mdt.de
Dynamic range
[Default value]
• not active, only on request
• on change
cyclic
•
• on change and cyclic
10%
•
• 20%
• 30%
10 s – 60 min
[5 min]
Comment
Setting of the sending condition for
the measured value.
Setting at which change the measured
value should be sent.
Only with selection "on change ..."
Setting whether and at what interval
the measured value is sent cyclically.
Only with selection „... cyclic".