Technical Manual
Twilight-/Temperature Sensor KNX [SCN-DTSEN1.01]
4.4 Temperature sensor
The following settings are available:
Figure 6: Settings – Temperature sensor
The table shows the possible settings
ETS-Text
Send measured value
Send on change of ...
Send cyclically
every ...
Calibration value for
sensor
(value x 0,1)
Smooth measured
value
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1 • Germany
13
Phone: +49-2263-880 • knx@mdt.de • www.mdt.de
:
Dynamic range
[Default value]
•
not active, only on request
on change
•
•
cyclic
•
on change and cyclic
•
10%
•
20%
30%
10 s – 60 min
[5 min]
-50 – 50 K
[0]
•
low
•
normal
high
•
Comment
Setting of the sending condition for
the measured value.
Setting at which change the measured
value should be
sent.
Only with selection "on change ..."
Setting whether and at what interval
the measured value is sent cyclically.
Only with selection „... cyclic".
Temperature adjustment for internal
sensor.
Setting for how the measured value
(dependence of brightness on
temperature) is compensated.