Twilight Sensor - MDT SCN-DTSEN1.01 Technical Manual

Technical Manual
Twilight-/Temperature Sensor KNX [SCN-DTSEN1.01]

4.3 Twilight sensor

The following settings are
Figure 5: Settings – Twilight sensor
The table shows the possible settings
ETS-Text
Send measured value
Send on change of ...
Send cyclically
every ...
Day/Night switchover /
Blinds control
„Day" if greater
than ...
„Night" if less
than ...
Send cyclically
every ...
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1 • Germany
11
Phone: +49-2263-880 • knx@mdt.de • www.mdt.de
available:
:
Dynamic range
[Default value]
not active, only on request
•
• on change
cyclic
•
• on change and cyclic
10%
•
• 20%
• 30%
10 s – 60 min
[5 min]
• not active
active
•
20 – 950 Lux
[380]
0 – 200 Lux
[10]
not active, 10 s – 60 min
Comment
Setting of the sending condition for
the measured value.
Setting at which change the measured
value should be sent.
Only with selection "on change ..."
Setting whether and at what interval
the measured value is sent cyclically.
Only with selection „... cyclic".
Activation of the function for
"Day/Night" switchover and a delayed
blinds movement.
Setting of the upper limit for the
threshold value.
Setting of the lower limit for the
threshold value.
Setting whether and at what interval
the measured value is sent cyclically.