Control And Display Elements; Model With Display; Model With Led - Beko METPOINT FLM SF53 Installation And Operation Instruction Manual

EN

2.4. Control and display elements

2.4.1. Model with display

METPOIN T
FLOW MEASURING
395,38
160515
AIR
HW:1.00 SW:1.00
NOTICE Additional information
For more information regarding the operation of the device, see "Configuration and operation" on page
27.

2.4.2. Model with LED

METPOINT
®
There is an LED on the top of the METPOINT
15 months to indicate there is an upcoming re-calibration. The flashing LED does not influence measured values. The measurement
signal is still output.
The time interval can be adjusted as requested by the customer in the manufacturing plant.
METPOINT SF53
®
F LM
®
m /h
3
m 3
FLM
FLM housing, which is used to indicate the calibration time. The light flashes after
®
Installation and operating manual
Plug-type connector A
Plug-type connector B
11