Intended Use; Warranty And Liability - Beko METPOINT FLM SF53 Installation And Operation Instruction Manual

EN

1.5. Intended use

The METPOINT FLM is a thermal flow meter for the measurement of volume flow, consumption and flow velocity. By default, the
®
device is configured for the measurement of volume flow in m³/h, consumption in m³ and velocity in m/s.
• The METPOINT FLM is primarily used in compressed air systems. On request, the sensor can be programmed by
®
BEKO TECHNOLOGIES GmbH for the measurement of other gases: Nitrogen
• The device is not suitable for operation in potentially explosive or aggressive atmospheres.
• Protect the device against direct sunlight and heat radiation.
Operate the METPOINT FLM only for the intended purpose and within the limit range specified in the technical data. Do not
®
operate the unit with any media (fluids, gas/vapor mixtures) other than those listed above. Any other use of the device is deemed
improper and poses a risk to persons, property and the environment.

1.6. Warranty and liability

Any liability claims shall expire if METPOINT
specifications indicated in the technical data; this includes, in particular:
• Incorrect installation, commissioning or operation; insufficient maintenance
• Operation with defective components
• Non-compliance with the instructions in this document, in particular the safety instructions
• Execution of construction related interactions or modifications of the device
• Non-compliance with the prescribed maintenance intervals
• Use of third-party spare parts that have not been approved by the manufacturer
METPOINT SF53
®
FLM is not used according to its intended use, or if it is operated outside of the
®
Installation and operating manual
7