NEC MultiSync LCD1990SXp User Manual page 20

Advanced OSM Controls
Tag 3 AUTO ADJUST
continued
LEVEL
(Analog input only)
A-NTAA SW
(Analog input only)
Tag 4 H. POSITION
V. POSITION
H. SIZE
(Analog input only)
FINE
(Analog input only)
Determines which items are to be adjusted when the AUTO
ADJUST function is activated.
The choices are "SIMPLE" "FULL", and "DETAIL".
Press "Left" or "Right" to select.
Size, Fine,
Position
SIMPLE O
FULL O
DETAIL* O
O: Automatic Adjustment X: No Automatic Adjustment
* "DETAIL" activates automatic long cable (skew, peaking) adjustment.
** Black level, RGB sharpness, RGB delay and RGB position can be adjusted using the
Long Cable Software. To download the software, please visit www.necdisplay.com.
The Advanced No Touch Auto Adjust function is able to recognize
new signals even when neither the resolution nor the refresh rate
has changed. If several PCs are connected to the monitor, and
each transmit very similar (or even the same) signals in terms of
resolution and refresh rates, the monitor recognizes that there is
a new signal and automatically optimizes the picture without the
need for any action on the part of the user.
OFF: A-NTAA is disabled.
ON: If a change in signal is detected A-NTAA will adjust the
monitor to the optimal settings for the new signal. If no change in
the signal is detected then A-NTAA does not activate. The screen
will be blank while the monitor optimizes the signal.
OPTION: Functions the same as ON, except that the screen does
not go blank when the monitor makes adjustments for changes in
signal, allowing the monitor to display the new signal faster. When
using an external switching device to connect 2 or more PCs to the
monitor, using the ON or OPTION settings is suitable.
Sets Horizontal Image Position within the display area of the
LCD. Press "Left" or "Right" to adjust.
Sets Vertical Image Position within the display area of the LCD.
Press "Left" or "Right" to adjust.
Increases or decreases the horizontal (or vertical) size.
If the "Auto Adjust function" does not give a satisfactory picture,
further tuning can be performed manually using the "H. Size (or
V. Size)" function (dot clock).
To manually adjust the monitor, a Moiré test pattern should be
used.
This function may alter the width of the picture. Use Left/Right
Menu to center the image on the screen.
(see page 11).
If the "Auto Adjust" and the "H.Size" functions do not give a
satisfactory picture, further tuning can be performed using the
"Fine" function. Increasing or decreasing this setting improves
focus, clarity and image stability.
(see page 11)
18
- continued
Contrast Black Level, Long
Cable capability**
X X
O X
O O
Time
1 Sec.
1.5 Sec.
5 Sec.