NEC MultiSync LCD1990SXp User Manual page 17

Controls
HOT KEY: When this function is activated, the brightness and contrast of the
monitor can be adjusted without entering the OSM menu.
The "Left" or "Right" buttons adjust the brightness level.
The "Down" or Up" buttons adjust the contrast level.
FACTORY PRESET: Selecting the factory preset allows the user to reset most of the
OSM control settings back to the factory settings.
Individual settings can be reset by highlighting the control that needs to be reset,
and pressing the RESET button.
Information Information
Provides information about the current resolution being displayed by the monitor.
Also provides technical information including which preset timing is being used as
well as the horizontal and vertical frequencies.
OSM WARNINGS: OSM Warning menus alert the user when there are problems
with the input signal. These warnings will disappear when the Exit button is pressed.
NO SIGNAL: This warning appears when there is no Horizontal or Vertical Sync.
After power is turned on or when there is a change of input signal, the No Signal
window will appear.
RESOLUTION NOTIFIER: This warning appears when the monitor detects a
resolution other than the optimized resolution. For the example, if the optimized
resolution for the monitor is 1280 x 1024 and a signal using a resolution of
1024 x 768 is detected, the "Resolution Notifi er" warning will appear.
OUT OF RANGE: This warns if the input signal is out of the optimized
resolution and refresh rate range that is used by monitor.
Note: It is possible to change the DVI selection or to change the IPM settings while
the "NO SIGNAL" or "OUT OF RANGE" messages are displayed.
For advanced user menu items see "Advanced OSM Controls".
– continued
15