Initial Server Setup - Cisco APIC M4 Installation And Service Manual

Initial Server Setup

Figure 12: Reversing the CMA
1 CMA tab on end of width-adjustment slider
Initial Server Setup
Note
Server Default Settings
The server is shipped with these default settings:
• The NIC mode is Dedicated (the only supported option in APIC).
• The NIC redundancy is None for Dedicated NIC mode.
• DHCP is enabled.
• IPv4 is enabled.
Connection Methods
There are two methods for connecting to the system for initial setup:
• Local setup—Use this procedure if you want to connect a keyboard and monitor directly to the system
Cisco APIC M4/L4 Server Installation and Service Guide
26
This section describes how to power on the server, assign an IP address, and connect to server management
when using the server in standalone mode.
for setup. This procedure can use a KVM cable (Cisco PID N20-BKVM) or the ports on the rear of the
server.
2 Metal button on outside of tab
Installing the Server