Table of Contents
Advertisement
Available languages
Available languages
Quick Start
LCD Setup
To attach the MultiSync LCD monitor to your system, follow these instructions:
1.
Make sure the computer and the LCD monitor are both turned off.
2.
Plug the end of the video signal cable of LCD monitor in the video signal connector of
the computer.
NOTE: To obtain the MultiSync Macintosh cable adapter, call NEC-Mitsubishi
Electronics Display of America, Inc. at (800) 632-4662.
3.
Plug the captive power cord into the female end of the AC adapter and power cord
into the AC adapter.
4.
Plug the power cord into a wall socket.
NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use
section of this manual for proper selection of power cord.
NOTE: Please use the supplied AC adapter.
5.
First, turn on the LCD monitor and then the computer.
6. Adjust the user controls to optimize your personal preference.
LCD15651765manual.p65
–continued
4
4
5/27/03, 8:31 AM
Hide quick links:
Advertisement
Table of Contents
