Table of Contents
Advertisement
Maintenance
General Tool Maintenance
1. During periods of storage, coat the bare
metal surfaces with light oil to inhibit rust.
Sharpening The Cutting Blade
1. Use an abrasive stone that is lubricated
with light oil or paraffin.
2. While wearing work gloves, use two hands,
one to grip the cutting blade to maintain the
angle. The other hand should exert an even
pressure just above the cutting edge.
Item 92553
For technical questions, please call 1-888-866-5797.
2. This product should be assembled
and stored in a dry area.
3. Move the cutting blade along the abrasive stone in a
figure-eight motion. Begin on the course side of the
stone and finish sanding on the fine side. Always
keep the blade at the same angle while sharpening.
4. After sharpening the blade there may be a
ragged burr on the cutting edge of the blade.
5. Remove this burr by gently rubbing the flat
side of the blade on a fine abrasive stone.
Page 7
Advertisement
Table of Contents
