Operation - Central Forge 92553 Owner's Manual & Safety Instructions

Operation

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
#4 Jack Plane
1. To remove the Blade (1), lift the lever
on Lever Cap Assembly (3) and remove
the Assembly from the Plane.
2. To remove the Chip Breaker from the Blade, remove
the Screw from the bottom of the Blade. You can then
sharpen or adjust the Blade. Replace Chip Breaker
(curved side down) and tighten Screw when finished.
3. To install and adjust the Blade, position it
over the Lever Cap Screw and ensure it is
properly aligned. Replace the Lever Cap
Assembly and tighten the Lever Cap Screw.
4. Adjust the Blade by pressing the Blade
Adjustment Lever (9) from side to side to
adjust the Blade angle. Turn the Adjustment
Screw (8) to adjust the Blade depth.
5. Make sure the workpiece is securely fastened down.
6. Do not force the Plane or press down on it. Move
it forward, taking off a little wood at a time. If the
Plane does not move forward easily, adjust the
Blade as explained in step 2 on previous page.
Note: If the Blade isn't planing properly, adjust
the Chip Breaker position up or down.
Mini Block Plane
1. To remove the Blade (1), loosen the Adjustment
Screw (4) and remove the Screw Cap (2).
2. You can then sharpen or adjust the Blade.
3. To install and adjust the Blade; position it over the
Plane Body (3) with the Screw Cap on top of it.
4. Turn the Adjustment Nut until the Blade is
held firmly in place in the desired position.
5. Make sure the workpiece is securely fastened down.
6. Do not force the Plane or press down on it. Move
it forward, taking off a little wood at a time. If the
Plane does not move forward easily, adjust the
Blade as explained in step 2 on previous page.
Note: If the Blade isn't planing properly, loosen the
Adjustment Screw and reposition the Blade up or down.
Item 92553 For technical questions, please call 1-888-866-5797.
Lever Cap
Lever Cap
Assembly (3)
Screw (4)
Frog
Assembly (5)
Chip Breaker
Screw (2)
Screw
Cap (2)
Blade (1)
Blade
Adjustment
Lever (9)
Adjustment
Knob (8)
Adjustment
Screw (4)
Blade (1)
Plane
Body (3)
Page 3