NEC MultiSync FE772M User Manual page 6

Quick Start
To attach the MultiSync™ monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Plug the end of the video signal cable of the monitor in the video
signal connector of the computer. (Figure A.1). Tighten all screws.
For the Mac: Connect the Macintosh cable adapter (not included) to the
monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini
D-SUB end of the video signal cable to the Macintosh cable adapter on
the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the Macintosh cable adapter, call NEC Display Solutions of
America, Inc. at (800) 632-4662.
4. Connect one end of the power cord to the MultiSync monitor and the other
end to the power outlet (Figure C.1).
NOTE: If you use this monitor at AC125-240V, please refer to Recommended
Use section of this manual for proper selection of power cord.
5. Turn on the monitor and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.

- continued