Data Transmission Test - Ebyte EA01-D Instruction Manual

Iot serial module

Table of Contents

2.2 Data transmission test

Before the test, please be sure that the power supply, antenna, SIM card (insert the notch outwards), serial cable and other hardware are well

connected.

(1) Visit the official website of Ebyte:

software;

(2) Select the corresponding COM No., the default serial port baud rate is 9600, 8N1, and configure the module by following the user manual;

(3) Check the signal strength, and set the device connection server IP and port No. as: 116.62.42.192, 8124; (Ebyte test server);

(4) Restart the module and await the device LINK light to be on;

(5) Follow the WeChat official account of "Ebyte" on the mobile phone, enter the page, and click in turn: Customer Support -> Device Test, as

shown in the below screenshot of the mobile phone page.

1. Send data using PC serial port tool, and send data to the device with mobile phone. The communication test results are shown in the following

figure:

www.ebyte.com

via PC browser, download the latest serial port tool, install the USB to serial driver, and run the

Table of Contents