Table of Contents
Advertisement
4
ASSEMBLY
20
Step 9:
Three wires come out of the upright, and three
wires come out of the console. Match the
connectors and connect these wires as shown
in Figure #20. The small wires are not slide-
specific; it doesn't matter if you connect them
to the right or left handlebar wires. Just match
the connectors and connect the wires.
Step 10:
The bottom of the console has an opening.
This opening fits onto the mounting bracket.
Once the wires are connected, carefully slide
the console down onto its mounting bracket
as shown in Figure #21. While sliding the
console into place, carefully tuck the wires
out of the way. Do not pull or pinch the wires.
Once the console is in place, secure its screws
as shown in Figure #22.
Secure the console screws but do not overtighten them.
PAGE 12
21
#18
22
Note:
Avoid Pulling or
Pinching Wires!
#18
Advertisement
Table of Contents
