Wakeup Pin; External Connections And Mechanical Drawings; Fig. 3.3: R7101C Lepton 7 X1 Mechanical Drawings And Connectors Locations (Units: Mm) - Caen RFID Lepton7x1 Technical Information Manual

Wakeup Pin

The WKUP pin is used to wake the device when it is in the Standby or Sleep operating modes. This pin is
edge sensitive and will wake the device on a rising edge. The WKUP pin must be logic low in order for the
device to re-enter Idle mode after a Sleep wakeup, so it should only be pulsed high to wake up the part.
The WKUP pin operates at a 3.3 V logic level. It has a 35 kΩ typical pull-down resistor inside the R7101C
Lepton 7 x1/R7104C Lepton
V should not be applied to the WKUP pin. This can cause permanent damage to the device.
If the WKUP pin is not used, it should be left floating or tied to logic low (ground).

External Connections and Mechanical Drawings

The location of the connectors is shown in Fig. 3.3: R7101C Lepton7x1 mechanical drawings and connectors
locations (units: mm) and Fig. 3.4: R7104C Lepton7x4 mechanical drawings and connector locations (units: mm).
Their part numbers are listed here below:
Antenna Ports: RF Coax Connector Huber+Suhner type 82_MMCX-S50-0-2/111_K (to be used with
Huber+Suhner type 11_MMCX-50-1-1/111_O)
MOLEX Connector: PCB Header Molex type 53261-1571 (to be used with Molex Type 51021-1500 + 15pcs
crimp terminal type 50058-8100)
Fig. 3.3: R7101C Lepton
HARDWARE INTERFACE - Lepton
7 x4. Voltages outside of the maximum IO operating voltage range of -0.3 to 4.0
7
x1 mechanical drawings and connectors locations (units: mm)
7 7
x1 - Lepton x4 - Technical Information Manual 14