Table of Contents
Advertisement
3 HARDWARE INTERFACE
Introduction
An example R7101C Lepton
shown in Fig. 3.1: Lepton7x1 R7101C/Lepton7x4 R7104C - Example of Block Diagram. This figure shows the
electrical connections that may and must be made to control the R7101C Lepton
the figure, the required connections are illustrated with solid lines. Recommended and optional
connections are illustrated with different dotted and dashed line patterns. More details for each
connection are listed in the following paragraphs.
7
Fig. 3.1: Lepton
x1 R7101C/Lepton
Required connections:
•
VDC_IN and GND are required to power the R7101C Lepton
•
RF is required to connect to the UHF RFID antenna.
•
UART1 Tx and Rx are required to communicate with the system host.
Recommended connections:
•
nRST is used to reset the R7101C Lepton
available. This connection is highly recommended. This pin is internally driven strong low during
software resets, so it should only be driven externally by an open drain signal. It must not be driven
strong high.
•
TST and BSL_SEL shall be used for the FW recovery/upgrade procedure.
In order to start the Boot Strap Loader of Lepton
signals shall be driven as in the picture below:
HARDWARE INTERFACE - Lepton
7
x1/R7104C Lepton
7
x4 system-level block diagram for an embedded system is
7
x4 R7104C - Example of Block Diagram
7
x1/R7104C Lepton
7
7
x1 - Lepton
x4 - Technical Information Manual
7
x1/R7104C Lepton
7
7
x1/R7104C Lepton
7
x4 if UART communication is not
7
internal microcontroller NRST, TST and BSL_SEL
7
x4. In
x4.
11
Advertisement
Table of Contents
