Cub Cadet 500 Series Operator's Manual page 17

Figure 6-3
4. Apply a very light coating of engine oil (or 3-in-1 oil) to the
hex shaft. See Figure 6-4.
NOTE: When lubricating the hex shaft, be careful not to get
any oil on the aluminum drive plate or the rubber friction
wheel. Doing so will hinder the snow thrower's drive
system. Wipe off any excess or spilled oil.
Figure 6-4
Adjustments
Shift Cable
If the full range of speeds (forward and reverse) cannot be
achieved, adjust the shift cable as follows:
1. Place the shift lever in the fastest forward speed position.
2. Loosen the hex nut on the shift cable index bracket. See
Figure 6-5.
Figure 6-5
3. Pivot the bracket downward to take up slack in the cable.
4. Retighten the hex nut.
5. If further adjustment is necessary move the shift cable to
one of the alternate holes in the shift cable index bracket.
Auger Control
Refer to the Assembly and Set-up section for instructions on
adjusting the auger control cable.
Skid Shoes
Refer to the Assembly and Set-up section for instructions on
adjusting the skid shoes.
S 6 — M
ection
& a
aintenance djuStMentS
17