Assembly - Husqvarna CG 200 Operator's Manual

WARNING:
working conditions from health and safety
point of wiew.
WARNING:
a confined or badly ventilated area can
result in death due to asphyxiation or
carbon monoxide poisoning. Use fans to
ensure proper air circulation when working
in trenches or ditches deeper the one meter
(3 foot).
WARNING:
highly flammable and can cause serious
injury when inhaled or allowed to come
in contact with the skin. For this reason
observe caution when handling fuel and
make sure there is adequate ventilation.
The exhaust fumes from the engine are hot
and may contain sparks which can start a
General
WARNING:
be switched off with the power cable
disconnected from the outlet.
To interchange the drums
1. Unscrew the three screws.
2. Remove the side plate.
3. Fit the drum and slid it on its shaft.
130 - 004 - 19.01.2023
Take into account the
Running an engine in
Fuel and fuel fumes are

Assembly

The product should
fire. Never start the product indoors or near
combustible material!
WARNING:
place any hot objects in the vicinity of fuel.
Safety instructions for maintenance
WARNING:
maintenance should be carried out with
the motor switched off and the plug
disconnected.
CAUTION:
out through the side plate. Product tilted
backwards rested on the handlebar leads to
damaging oil leakage.
We recommend that the respect of the maintenance
intervals and periodical checks should be obey and
implemented and only genuine spare parts be used for
repairs and maintenance.
To connect the dust extractor
Always use a vacuum cleaner to minimize dust. Make
sure that the filters in the vacuum cleaner are intact and
clean. Pay attention to dust during operation.
1. Connect the dust extractor (1) to the product.
Do not smoke and do not
Inspection and/or
Drum inspection is carried
7