Husqvarna CG 200 Operator's Manual page 6

Safety instructions for operation
WARNING:
basic safety directions for using the product.
This information is never a substitute for
professional skills and experience. If you get
into a situation where you feel unsafe, stop
and seek expert advice. Contact your dealer,
service agent or an experienced user. Do
not attempt any task that you feel unsure of!
WARNING:
the engine is started.
WARNING:
Use gloves/safety gear.
Those who operate this product should be competent
staff (qualifications, age, training) who have read and
understood the manual in detail before starting work.
Any electrical, mechanical or other problem should
be investigated by a qualified maintenance engineer
(electrician, maintenance manager, approved dealer,
etc .).
• When the product is recived check its condition.
• Always keep the product clean.
• Always keep alert when working.
Electrical safety
This product should always be operated with the correct
electrical supply.
WARNING:
shocks from electrically powered products.
Avoid unfavourable weather conditions and
body contact with lightning conductors and
metal objects. Always follow the instructions
in the Operator's manual to avoid damage.
Never connect the product to a outlet if plug
or cord is damaged.
WARNING:
result in the risk of electric shock. Contact a
qualified electrician if in doubt as to whether
the appliance is properly grounded. Do not
modify the plug. If it will not fit the outlet
have a proper outlet installed by a qualified
electrician. Make sure local regulations and
ordinances are followed. If the grounding
instructions are not fully understood contact
a qualified electrician.
• Check regularly that the engine is serviced (fuel
engine), the state of the supply cable and extension
cable (for electric motor).
6
This section describes
The toolshaft rotates when
Be aware of hot muffler.
There is always a risk of
Improper connection can
• Check the mains voltage. See
data on page 12 .
• Check that the motor is connected to electric cable
with conductors of 4 mm
than 100 m. Above this length, double the section.
WARNING:
cables. They can cause serious, even fatal,
personal injuries.
CAUTION:
depends on proper voltage. Extension
cables that are too long and/or which have
a gage that is too small, reduce power to the
motor under load.
Personal protective equipment
WARNING:
personal protective equipment whenever
you use the product. Personal protective
equipment cannot eliminate the risk of injury
but it will reduce the degree of injury if an
accident does happen. Ask your dealer for
help in choosing the right equipment.
WARNING:
as cutters, grinders, drills, that sand or
form material can generate dust and vapors
which may contain hazardous chemicals.
Check the nature of the material you
intend to process and use an appropriate
breathing mask. Long-term exposure to
noise can result in permanent hearing
impairment. Always use approved hearing
protection.Listen for warning signals or
shouts when you are wearing hearing
protection. Always remove your hearing
protection as soon as the engine stops.
Always wear:
• Approved protective helmet.
• Hearing protection.
• Approved eye protection. If you use a face shield
then you must also wear approved protective
googles.
• Breathing mask.
• Heavy-duty, firm grip gloves.
• Tight-fitting, heavy-duty and comfortable clothing
that permits full freedom of movement.
• Boots with steel toe-caps and non-slip sole.
• Always have a first aid kit nearby.
Fuel safety
The level of the fuel and oil need be checked regularly.
Consult the engine manufacturer manual if necessary.
Equipment technical
2
section for lengths less
Never use damaged
Good motor performance
You must use approved
The use of products such
130 - 004 - 19.01.2023