Wiegand Data Output; Guard Telephone; Call Waiting - Alpha Communications TekTone Tek-ENTRY Operation, Installation And Service Manual

System Introduction
®
2 • IL574 Tek-ENTRY

Wiegand Data Output

This feature connects Tek-Entry
When a tenant approves a visitor, the tenant's code is sent to the card access system,
causing the door to open.

Guard Telephone

The guard telephone must be a standard touchtone (DTMF) phone, and is connected
directly to the PM900 Control Unit via two conductors. To communicate with a tenant,
the guard must wait for a dial tone and then enter the tenant's 4-digit relay number. (The
guard will not receive a dial tone while the lobby panel is in use.) To dial an off-site
telephone, dial "9," wait for a dial tone, and then dial the desired telephone number.
Conversation time is limited to 100 seconds.
NOTE: Dialing an off-site telephone uses requires a telephone line to be connected
directly to the PM900 Control Unit. Because it is used infrequently and only for short
periods of time, this does not need to be a dedicated telephone line—it can be shared
with an office phone, for example. The same line is also used to dial up to five off-
premises phone numbers from the entry panel, if programmed.

Call Waiting

If a tenant is on the telephone when called from the lobby panel or guard telephone, they
will hear a double tone to announce the visitor. Depress the hook switch to place the
outside call on hold and speak with the visitor. Depress the hook switch again to switch
back to the outside call.
No-Phone-Line Version Manual
®
to a card access system with a Wiegand 26-bit input.
Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.