Table of Contents
Advertisement
System Installation and Programming
®
8 • IL574 Tek-ENTRY
View Keyless Entry Codes
This section allows the review and/or deletion of keyless entry codes.
1. When the programming menu displays "VIEW KEYLESS CODES," press the "#"
key. The message "CODE TO REVIEW _____" will appear.
2. Enter the four-digit keyless entry code to be reviewed. The keyless entry code will be
displayed.
3. To delete the displayed keyless entry code, press the "#" key.
4. To view all keyless entry codes, use the "1" key to scroll up, and the "3" key to scroll
down.
5. Press the "*" key to return to the programming menu.
6. If desired, press the "*" key to end program mode.
New Master Code
The master code is used to access the program mode. When the entry system is shipped
from the factory, its master code is set to "*123." It is advisable to change the master
code and record the new code in the appropriate place on the Tek-ENTRY
Worksheet. The master code is used by the installation company or by authorized personnel,
only when programming is necessary. To change the master code:
1. When the programming menu displays "NEW MASTER CODE," press the "#" key.
The message "MASTER CODE *123" will appear.
2. Enter a new three-digit master code and press the "#" key to save.
3. Press the "*" key to return to the programming menu.
4. If desired, press the "*" key to end program mode.
Door Open Time
The door open time can be reprogrammed to 0-99 seconds to prevent tailgating. Factory
default is 10 seconds. See Door Timer Cut-Off in the System Introduction—Special
Features section for more information.
1. When the programming menu displays "DOOR TIME," press the "#" key. The
message "DOOR OPEN TIME" will appear.
2. Enter a two-digit time in seconds and press the "#" key to save.
3. Press the "*" key to return to the programming menu.
4. If desired, press the "*" key to end program mode.
Talk Time
Talk time can be reprogrammed to 0-99 seconds to set the maximum conversation length
between a visitor and tenant. (Note: Talk time starts when visitor dials tenant.) Factory
default is 60 seconds.
1. When the programming menu displays "TALK TIME," press the "#" key. The
message "ON LINE TIME" will appear.
2. Enter a two-digit time in seconds and press the "#" key to save.
3. Press the "*" key to return to the programming menu.
4. If desired, press the "*" key to end program mode.
Pulse or Tone Dialing
This section determines whether pulse or tone (DTMF) dialing is used to call off-premises
telephones. Factory default is tone dialing. If the outside telephone line is pulse (rotary),
change this setting:
1. When the programming menu displays "PULSE OR TONE," press the "#" key.
2. Enter "00" for pulse (rotary) dialing; or enter "11" for tone (DTMF) dialing. Press the
"#" key to save.
3. Press the "*" key to return to the programming menu.
4. If desired, press the "*" key to end program mode.
No-Phone-Line Version Manual
Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.
®
Programming
Advertisement
Table of Contents
