Table of Contents
Advertisement
System Installation and Programming
Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.
®
Complete the Tek-ENTRY
Directory Worksheets and the User Operating Instructions are given to building management
when installation and programming are complete.
Program Mode—Begin/End
Enter "*" and the three-digit master code (default is *123) to begin a programming session.
Use the "1" key on the keypad to scroll up the programming menu and the "3" key to
scroll down. When the desired function is displayed on the screen, press the "#" key to
select it. Follow the displayed instructions to make the necessary changes. When
programming is complete, end program mode by pressing the "*" key twice.
To Program Codes (Tenant Dial Codes)—Manual Method
Tenant dial codes are used at the entrance panel to call a tenant, and are usually listed on
a tenants directory. Suite numbers may be used as tenant dial codes, if desired. To manually
program the tenant dial codes that correspond to the tenant line relays:
1. When the programming menu displays "VIEW/ENTER CODES," press the "#" key.
The message "RELAY TO REVIEW" will appear.
2. Enter "0000" to begin with the first relay. The message "RELAY 0000" will appear,
along with its corresponding tenant dial code.
3. To view all keyless entry codes, use the "1" key to scroll up, and the "3" key to scroll
down.
4. To program the displayed relay, press the "#" key and then the new 4-digit tenant dial
code. Press the "#" key to save. Continue in this fashion until tenant dial codes have
been entered for all relays. If a tenant dial code is fewer than 4 digits in length, enter
zeros as leading digits. The leading zeros are not needed during actual use, but are
required during programming. If an error is made when entering a tenant dial code,
press the "*" key to backspace.
5. Press the "*" key to return to the programming menu.
6. If desired, press the "*" key to end program mode.
To Program Codes (Tenant Dial Codes)—Automatic Method
Tenant dial codes are used at the entrance panel to call a tenant, and are usually listed on
a tenants directory. Automatic programming assigns tenant dial code 0000 to relay #0,
tenant dial code 0001 to relay #1, etc. To automatically program the tenant dial codes to
correspond to the tenant line relays:
1. When the programming menu displays "AUTO PROGRAM, PRESS #," press the "#"
key. The message "ARE YOU SURE?" will appear.
2. Press the "#" key. The message "PROGRAMMING PLEASE WAIT" will appear.
The system automatically programs tenant dial codes in sequence from 0000 to 0999
(a total of 1000 codes). Automatic programming takes approximately 20 seconds.
3. Press the "*" key to return to the programming menu.
4. If desired, press the "*" key to end program mode.
Program Keyless Entry Codes
Keyless entry codes allow tenants to enter through the controlled doors using a four-digit
code from the system keypad, rather than a key. During actual use, this code must be preceded
by the "#" key so that the code is not visible on the display. For security, assign each tenant a
unique keyless entry code, and do not duplicate any suite numbers or tenant dial codes.
1. When the programming menu displays "PROGRAM KEYLESS CODES," press the
"#" key. The message "KEYLESS ENTRY CODE #____" will appear.
2. Enter a four-digit code and press the "#" key to save. Continue entering keyless entry
codes until all are entered.
3. Press the "*" key to return to the programming menu.
4. If desired, press the "*" key to end program mode.
IL574 Tek-ENTRY
Programming Worksheet, and ensure that it, the Tek-ENTRY
®
No-Phone-Line Version Manual • 7
®
Advertisement
Table of Contents
