Advertisement
Testing
Disconnect the charge lead and press the button on your CoolPower front panel
whilst your fridge is running.
Voltage
Your battery voltage will appear on the digital display. The precise remaining
capacity will vary depending on conditions such as ambient temperature, but as a
general guide will be as follows:
Voltage
12.8V or more
12.3V to 12.7V
11.3V to 12.2V
LED's (on front panel)
A quick visual indication of the condition of your CoolPower can be obtained at a
glance. After disconnecting charging leads and pressing the test button:
LED indicator
'FULL' green ON
Both OFF
'LOW' red ON
Charging
In-car (12V)
• Plug the charge lead 2-pin screw connector into the 'CHARGE' socket on the
left hand side of your CoolPower. Then plug the 12 volt plug on the other end of
the charge lead either directly into your vehicle 12 volt socket, or (recommended)
into the WAECO RAPS12R-U2 heavy duty wiring kit socket pre-fitted to your
vehicle.
• When the CoolPower is accepting charge from your vehicle battery, the green
LED adjacent to the 'CHARGE' socket will illuminate.
240V mains
• Ensure the battery charger is suitable for 44Ah AGM batteries.
• Most multi-stage battery chargers up to 15A maximum should be suitable
WAECO CoolPower 44
Capacity
80% - 100%
40% - 80%
20% - 40%
Voltage
12.8V or more
11.4V to 12.7V
11.3V or less
Action Required
None
Charging optional
Must charge
5
Advertisement
