Table of Contents
Advertisement
Advanced tab
Car direction
Vehicles should be filmed from the front for recognition in
order to get the best results (except for specific countries like
Switzerland or sometimes Italy).
In some specific cases, vehicles are coming from both
directions in the same lane. In theses cases, it can be
needed that recognition is done only for cars coming from
one of the two directions:
• BOTH: enabling this function (default value) will allow
recognition of vehicles going forward and backward of the
lane.
• FRONT: enabling this function will allow recognition of
vehicles coming from the front.
• REAR: enabling this function will allow recognition of
vehicles coming from the rear.
Click on "APPLY" button and wait for approximately 15
seconds for the parameters to take effect.
Relay 1
The relay 1 can be located on the chapter Wiegand
Connector Side View (page 8). Connect the desired device to
the relay 1 using the pins – ALARM OUT 1 and + ALARM
OUT 1.
The programmable options of the relay 1 are:
• Always OFF
Select this option to switch OFF the relay 1 constantly.
• Always ON
Select this option to switch ON the relay 1 constantly.
• ON for a reliable number plate
Select this option to switch ON the relay 1 when a reliable
licence plate is detected. The relay 1 will switch OFF after the
specified duration (refer to part "Duration" below).
• ON for an unreliable number plate
Select this option to switch ON the relay 1 when an unreliable
licence plate is detected. The relay 1 will switch OFF after the
specified duration (refer to part "Duration" below).
• Duration (ms)
This is the time during which the Relay 1 will be ON before it
goes OFF. This time is set in milliseconds.
Relay 2
The relay 2 can be located on the chapter Wiegand
Connector Side View (page 8). Connect the desired device to
the relay 2 using the pins – ALARM OUT 2 and + ALARM
OUT 2.
The programmable options of the relay 2 are the same as the
relay 1.
Minimum Luminosity Index
This value corresponds to the starting point of the Automatic
Shutter Speed Algorithm.
Default value is index 0.
If needed, this should be the maximum bright conditions of
recognition, for example during a very sunny day.
Maximum Luminosity Index
This value corresponds to the last reference of the Automatic
Shutter Speed Algorithm.
Page 32 / 42
Advertisement
Table of Contents
