Advanced; Network Management - Sony SNC-EMX30R User Manual

Network camera
Click Set to apply the changes.
4.7.3

Advanced

RTSP port
If necessary, select a different port for the exchange of the RTSP data from the list. The
standard RTSP port is 554. Select Off to deactivate the RTSP function.
Authentication (802.1x)
To configure Radius server authentication, connect the unit directly to a computer using a
network cable. If a Radius server controls access rights over the network, select On to activate
authentication to communicate with the unit.
1.
2.
TCP metadata input
The device can receive data from an external TCP sender, for example an ATM or POS device,
and store it as metadata. Select the port for TCP communication. Select Off to deactivate the
function. Enter a valid Sender IP address.
Syslog
Server IP address
Enter the appropriate IP address of the server.
Server port (0 = Off)
Enter the number of the server port.
Protocol
Select the appropriate protocol: UDP, TCP, or TLS.
LLDP power config
Requested for camera
The value in this field identifies the number of watts requested for the camera.
Additional Power
Enter the number of additional watts that you want the camera to use.
Requested total
The value in this field is the total number of watts from the fields Requested for camera and
Additional Power.
Allocated power
The value in this field is the number of watts of allocated power to the camera.
Click Set to apply the changes.
4.7.4

Network Management

SNMP
The camera supports the SNMP V1 legacy (Simple Network Management Protocol) and SNMP
V3 for managing and monitoring network components, and can send SNMP messages (traps)
to IP addresses. It supports SNMP MIB II in the unified code.
If On is selected for the SNMP parameter and a SNMP host address is not entered, the device
does not send the traps automatically and will only reply to SNMP requests. If one or two
SNMP host addresses are entered, SNMP traps are sent automatically. Select Off to
deactivate the SNMP function.
SNMP host addresses
To send SNMP traps automatically, enter the IP address of one or two target devices here.
Sony Corporation
Enter the user name that the Radius server uses for the unit in the Identity field.
Enter the Password that the Radius server expects from the unit.
User manual
Configuration | en 91
2019-07 | V01 | DOC