Attaching The Wrap-Around Tape; Troubleshooting; Specifications; Compatible Printers For This Product - Partex ProMark T-2000 User Manual

1
Unfold the tape as shown in the
figure, and remove only the printed
part (white) from the peeling film.
NOTE
• The tip of the tape has a margin necessary for printing.
• The printed tape has a slit. Pull the joined parts to separate them as shown.
The tape has gotten into the cassette
Use tweezers to pull out
the tape tip, as shown in
the figure.
External tape dimensions: 33 mm (length) x 8 m roll
Materials: Label/Backing Film: PET, Cassette: ABS/PP
This product is compatible with the printer in <Fig. A>, cannot be used with the printer in <Fig. B>.
T-2000 / T-2000c
<Fig. A>

ATTACHING THE WRAP-AROUND TAPE

2
Attach the printed part (white) to the
cable, and then remove all the peeling
film from the laminated seal part.
3
Wrap the transparent
laminated seal part so that
it covers the printed part.

TROUBLESHOOTING

SPECIFICATIONS

COMPATIBLE PRINTERS FOR THIS PRODUCT

The tape is not cut properly
If the slit in the tape is too shallow (or too deep)
or tape is not cut, adjust the cut depth. If problems
persist after adjustment, replace the cutter. For
details, refer to the instruction manual for the printer.
Storage conditions: Temperature: 5-35°C (41-95°F)
Relative humidity: 35-85%
T-1000, T-800, MK8
2 / 2
<Fig. B>.
© Partex Marking Systems 2022