Advertisement
CONTROLS
1/ Looking at the angle grinder from the top, the spindle lock (2) is located at the front top right hand
side.
2/ There are attachment points (4) for the handle (6) at either side of the front of the housing, Attach the
handle in the position that suits the planned operation.
3/ An arrow imprinted on the front housing indicates the direction of the rotation of the Disc.
4/ The on/off switch (5) is located on the top of the motor housing.
5/ The adjustable disc guard (3) is on the underside of the grinder as is the outer flange (9), grinding
disc (10)
Operation
This angle grinder can be used for polishing cutting and grinding.
1/ To start the grinder first ensure that the
work you are going to do has the right
disc for the job.
2/ When using cutting or grinding disc,
insure that the guard (3) and tools are
in good condition.
3/ Position the guard (3) when using disc so that it will deflect hot sparks away from operator.
4/ Plug the cord set into the mains outlet.
5/ Push the on/off switch (5) forward and up over the latching ramp to lock the switch on
7/ Allow the grinder to start and attain full speed before bringing the grinder to the work piece.
8/ When using cutting and grinding discs hold the grinder at 15 to 30 to the work surface moving
slowly
9/ Hold the grinder firmly while it is switched on and only apply gentle pressure to the workpiece
little more than the weight of the tool should be applied to give the best and most efficient material
removal. Forcing and excessive pressure can cause dangerous disc fracture or damage to the tool
10/Avoid flying sparks. And ensure they do not hit any inflammable materials, as they are very hot and
could cause personal injury or a fire.
11/Once you have finished the job you are
latching ramp to stop the angle grinder.
12/If a person comes to you while you are operating the machine do not turn round or look up until
you have released the trigger and the machine has come to a stop and you have put the machine
down then you are safe to communicate with that person.
13/WARNING. The grinder continues for a few seconds after the trigger has been released, so be
careful when placing the tool down, make sure it has stopped.
doing, press
the back of the switch (5) and lift it over the
Advertisement
