Asus ISDNLINK TA-200 Manual page 18

Installation for Windows NT 4.0 Environment
Installing and Configuring the Drivers
Run any terminal program such as Terminal, ProComm ... and configure the
1.
parameters as follows
Baud Rate:
Data Bit:
Parity Check:
Stop Bit:
Flow Control:
If you need to alter the default settings then please refer to the above section (How to
Configure TA-200). Please note, the set values of Country or switch type, SPID0 and
SPID1, CODEC, MSN, and Outgoing telephone number will be stored in the adapter
and will not alter until the customer changes them using the AT@ configuration screen.
Install ASUSCOM ISDN modems for Dial-up Networking and RAS.
2.
Please use the following steps to add the virtual modems under Windows NT.
1) Select Start
Access Service, Properties
my modem, I will select it from a list". Click " Next" .
2) Click "Have Disk", and browse to the modem sub-directory (A:\MODEM) on the
18
.
Up to 115200
8
None
1
RTS/CTS
à à
Settings Control panel
à
Add
© COPYRIGHT OF ASUSCOM NETWORK INC.
à
Network
à à
Install Modem
à à
Services Remote
Check "do not detect