Asus ISDNLINK TA-200 Manual page 13

want to change the login.cmd file, you can dial into the ISP by manual login (enter ATB4 or
ATB41 first, and then ATD######).
Installation for Windows 95 Environment
The TA-200ST is a Windows 95 PnP compatible device so Windows 95 will prompt a
message and request you to install the driver when boot up. When requested insert
the installation disk into the floppy drive and select the option for Hardware Vendor
providing device driver. If your Windows 95 is OSR2 version, you will see the screen
shown below. Windows 95 will then automatically process the driver installation
procedure and install an "ISDN TA (Async. to Sync. PPP, 64K) Modem" for Internet
access. (Please note that this modem is really just a ' standard' modem but modem
properties set to 115K baud and the initialization command ATB4 set in the advanced
settings. All the TA-200 modem drivers are basically the same but with different
initialization commands.)
Installing and Configuring the Drivers
Run any terminal program such as Terminal, ProComm ... and configure the
1.
parameters as follows.
Baud Rate:
Data Bit:
Parity Check:
Stop Bit:
Flow Control:
If you need to alter the default settings then please refer to the above section (How to
Configure TA-200).
and SPID1, CODEC, MSN, and Outgoing telephone number will be stored in the
adapter and will not alter until the customer changes them using the AT@
Up to 115200
8
None
1
RTS/CTS
Please note, the set values of Country or switch type, SPID0
© COPYRIGHT OF ASUSCOM NETWORK INC.
13