Table of Contents
Advertisement
%DT
Set AT Command Mode Timer
Description:
Sets the length of time that the command mode will be disabled when set for %DC1
(the modem ignores AT commands).
Note:
Syntax:
AT%DT<value>
Values:
0-255 in 1 second increments
Default:
0
%E
Fallback and Fall Forward Control
Description:
This command provides the option for the modem to automatically monitor line
quality, to fall back when line quality is insufficient, and to fall forward when line
quality is sufficient.
Syntax:
AT%E<value>
Values:
0
1
2
Default:
2
Result Codes:
OK if <value> = 0, 1, 2.
ERROR if <value> ≠ 0, 1, 2.
%H
Set Callback Security – Direct Connect Enable
Description:
Sets Callback Security to normal operation or to direct connect.
Note:
Syntax:
AT%H<value>
Values:
0
1
Default:
0
%S
Command Speed Response
Description:
Sets the modem to respond to AT commands at desired speeds.
Note:
Syntax:
AT%S<value>
Values:
0
1
Default:
0
Multi-Tech Systems, Inc. AT Commands for the MultiModem & SocketModem MT9234 Series (S000434D)
Chapter 1 – AT Commands, S-Registers, and Result Codes
This command does not apply to the parallel build.
Disable fallback and fall forward.
Enable fallback and disable fall forward.
Enable fallback and fall forward.
This command does not apply to the parallel build.
Sets callback security to normal operation.
All callback security calls will be direct connect regardless of whether the
password or phone number has the - character.
This command does not apply to the parallel build.
Sets modem to respond to AT commands at all normal speeds.
AT commands accepted at 115200 bps only. Other speeds are ignored.
21
Advertisement
Table of Contents
