Advertisement
Linear LNB Replacement Instructions
Follow the instructions below to replace a linear
LNB with a new linear LNB of the same type.
LNB types are shown in Figure 5.
NOTE: If you need to replace a circular LNB instead,
refer to "Circular LNB Replacement Instructions" on
page 2.
Step 1 - Remove the Radome
Follow the steps below to remove the radome.
CAUTION
For your own safety, be sure to disconnect
power from all wired components before
performing this procedure.
a. Disconnect power from the TracVision
system and any connected receivers and/or
multiswitch.
b. Remove the eight Phillips screws securing the
radome to the baseplate. Then set the radome
aside in a safe place (see Figure 6).
4
Figure 5 LNB Types
Dual-output
Compact
Linear
Circular
Quad-output
Linear
Figure 6 TracVision M9 Radome Screws
Antenna
Galaxy
(Circular)
Conventional
Circular
Radome
#10-32
Screw (x8)
Baseplate
Advertisement
