Omron G3PX EUN Series Manual page 8

G3PX
Mounting
Mount the Power Device Cartridge as follows:
1. Apply silicone grease (provided with the G32X-A) to the entire
surface of the heat sink.
2. Make sure there is no dust or pieces of wire on the heat sinks
of the G32X-A or the G3PX.
3. Insert the Cartridge into the opening of the G3PX so that the
letters on the Cartridge and those on the G3PX are in the
same direction and sides A and B are even.
A
B
4. Attach the terminal cover.
5. Switch on the power and check the G3PX to be sure it works
properly.
G32X-A40/60
The G32X-A40 and G32X-A60 are secured with screws.
Extraction
Remove the Power Device Cartridge as follows:
1. Switch off the G3PX.
2. Remove the terminal cover.
3. Be sure to turn off the G3PX and loosen the screws located in
the upper center and lower center. These screws are
connected to terminals 1 and 2.
Loosen
8
Mounting
Loosen
4. Loosen the screws on both corners.
Loosen
5. Hold the indented part of both corners to remove the
Cartridge.
1. Apply silicone grease (provided with the G32X-A) to the entire
surface of the heat sink.
2. Make sure there is no dust or pieces of wire on the heat sinks
of the G32X-A or the G3PX.
3. Insert the Cartridge into the opening of the G3PX so that the
letters on the Cartridge and those on the G3PX are in the
same direction and sides A and B are even.
A
B
4. Tighten the screws on both corners with a tightening torque of
0.59 to 0.78 N S m.
5. Tighten the center screws of the G3PX with a tightening
torque of 0.59 to 0.78 N S m.
6. Attach the terminal cover.
7. Switch on the power and check the G3PX to be sure it works
properly.
G3PX
Loosen