Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS FOR JOHN DEERE 6000 SERIES
INSTALLATION OF FENDER SUPPORT FOR 10 AND 50 SERIES ONLY
1. Open the right side access door behind and right wheel and underneath the fender. With this
access door open, the C channel can be seen looking inside and up.
2. Remove the forward two of the linkage bolts on the wheel side of the C-channel.
3. Remove the bolt holding the cluster of wires on the blower side.
4. Remove the two larger bolts toward the rear.
5. *Note the nuts from these four bolts are not used because the support bracket has the nuts
welded directly to it.
6. Raise the support bracket up so the C channels oppose each other.
7. Reinstall bolts, threading them to the support bracket.
INSTALLATION OF THE TANK AND FRAME
1. Locate the holes on the right fender of the machine. The holes may have been pre-drilled at
the factory.
2. Lift the tank assembly up onto the fender. The pump assembly will be on the outside and to
the back of the fender.
3. Bolt the sprayer in place with ½" x 1 ½" bolts, nuts, and locks; fender washers should be
placed under the fender for extra support.
3
Advertisement
Table of Contents
