Table of Contents
Advertisement
User Guide | Danfoss Gas sensor, type DGS
Menu overview
(continued)
5.1 Error status
12 | BC291049702513en-000201
Start menu
Main menu
Service
OFF
The following menu items are only accessible with Service ON (password protected)
!! Service ON = special mode = fault message is active!!
Alarm reset settings
Alarm settings
AO Settings
Operating Data
Calibration
Addressing
A pending fault activates the yellow LED (Fault). The first 50 pending errors are displayed in the menu
"System Errors".
A number of error messages may be displayed related to the sensor: Out of Range, Wrong type,
Removed, Calibration due, Voltage Error. "Voltage Error" refers to the supply voltage. In this case the
product will not go into normal operation until the supply voltage is within the specified range.
See chapter 5.6
See chapter 5.7
See chapter 5.8
See chapter 5.9
See chapter 5.10
See chapter 5.11
© Danfoss | Climate Solutions | 2022.01
Advertisement
Table of Contents
Need help?
Do you have a question about the DGS Series and is the answer not in the manual?