Table of Contents
Advertisement
Figure 4
DIP switch settings for IR and
RF modes
Note
Do not set both DIP switch
positions 1 and 2 to the ON
position, or the batteries may
prematurely lose power.
Figure 5
TXC4 DIP switch location and
orientation
TXC Wireless Transmitters
IR, RF, Radio Code, and IR
Frequency Settings
Overview
The TXC series transmitters transmit IR or RF signals, depending on how you set
positions 1, 2, and 3 on the 10-position DIP switch (Figure 4) located under the
battery cover. You must set the DIP switch position 3 to ON for RF mode.
IR, RF, and IR Frequency Settings
Figure 4 shows the DIP switch settings for IR and RF modes.
ON
1
2 3
4 5
6 7
8
38 kHz IR mode
Radio Code
Each pushbutton on your transmitter represents an AXCESS channel number. All of
the pushbuttons on a transmitter represents a group of channel numbers. This
grouping is known as a radio code. After the radio code is set on the transmitter,
each button you press sends a specific channel number to the control system. For
example, if your TXC16+ transmitter is set to radio code 4 and you press button 1,
channel number 64 is sent to the control system (Figure 7).
ON
1 2 3 4 5 6 7
8
455 kHz IR mode
ON
1
2
3
4
5
6
IR, RF, Radio Code, and Frequency Settings
ON
1 2 3 4 5 6 7
8
RF mode
7
8
5
Advertisement
Table of Contents
