Page 1
instruction manual TX-CTB Classroom Transmitter and Barcode Reader Tran s m it t er s...
Page 2
This warranty extends only to products purchased directly from AMX Corporation or an Authorized AMX Dealer. AMX Corporation is not liable for any damages caused by its products or for the failure of its products to perform. This includes any lost profits, lost savings, incidental damages, or consequential damages. AMX Corporation is not liable for any claim made by a third party or by an AMX Dealer for a third party.
Table of Contents Product Information ...1 Setting the IR Frequency... 1 Using the TX-CTB ...3 Television Control... 3 Modes... 3 Local Mode... 3 Media Mode ... 4 Office, Security, or Media Center Control... 4 Calls ... 4 System Media Control ... 4 Motion ...
Page 4
Table of Contents TX-CTB Classroom Transmitter and Barcode Reader...
Product Information The AMX Synergy Classroom Transmitter/Barcode Reader (TX-CTB) provides a full range of control options for a Resource Management System (RMS). It transmits Infrared (IR) format commands to classroom Television Managers. TX-CTB Specifications Dimensions (HWD): 5.25" (133 mm) x 6.26" (159 mm) x 0.75" (19.05 mm)
Page 6
Product Information TX-CTB Classroom Transmitter and Barcode Reader...
Using the TX-CTB Television Control The TV control buttons operate the classroom television. The following functions are always available: ON/OFF turns on or off the classroom television power. Only the adminstrator can control television power. VOLUME controls the television volume. Press the up or down arrows to manipulate the volume.
Using the TX-CTB Media Mode Media Mode is active whenever there is a media source, broadcast channel, or media plan scheduled to a classroom. You can select up to 10 sources. Press SOURCE play assigned media source. Press SOURCE and play assigned media source. Office, Security, or Media Center Control Calls There are two different kinds of calls that you can send:...
Laser Disc The selected source must accept a Chapter and/or Frame command. Chapter: To play a specific chapter, press CHAPTER, the chapter number then ENTER. Frame: To play a specified frame, press FRAME, the fame number, then ENTER. Clear: To cancel commands, press CLEAR, then ENTER. Audio: To control audio, press ALT and one of the following number buttons: Left channel (analog) Right channel (analog)
Using the TX-CTB Computer To control the CD-I mouse, use the buttons labeled in yellow. Then, press one of the eight outer number buttons (1 – 4 or 6 – 9). For information on the Speed and how to activate functions refer to the CD-I Player subsection.
Page 11
Using the TX-CTB TX-CTB Classroom Transmitter and Barcode Reader...
Page 12
AMX reserves the right to alter specifications without notice at any time. brussels • dallas • los angeles • mexico city • philadelphia • shanghai • singapore • tampa • toronto • york 3000 research drive, richardson, TX 75082 USA • 469.624.8000 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993...