Table of Contents
Advertisement
OPERATION CHECK-2
1.OPERATION CHECK(2/2)
1-7. CONFIRMATION OF HDMI MAIN OUTPUT OSD(ON SCREEN DISPLAY) OPERATION
a. When SETUP button is pushed, confirm that setup menu is displayed in HDMI Out.
b. Confirm that specified operations for ENTER(with 4-cursor) buttons are made.
1-8. CONFIRMATION OF HDMI AUDIO OPERATION.
See "OPERATION CHECK-3, -6" for TEST MODE operation.
CONFIRMATION OF HDMI I2S SIGNAL
a. Input the one of these signals below from HDMI1 terminal.
DTS-HD MasterAudio 7.1ch
Dolby TrueHD 7.1ch
LPCM 7.1ch
b. Change the state to TEST 6-00. Confirm the signal is output from L/R,SW/C,SL/SR,SBL/SBR.
c. When TEST 6-08, confirm the sound(HDMI1 input) outputs from the TV.
CONFIRMATION OF HDMI SPDIF SIGNAL
d. SPDIF signal is input from HDMI terminal.
e. When TEST 6-06, confirm the sound(HDMI IN1) outputs from the speaker.
f. When TEST 6-07, confirm the sound(BD/DVD analog input) outputs from the TV.(VIDEO is HDMI1)
CONFIRMATION OF HDMI DSD SIGNAL
g. When TEST 6-10,11,12, confirm the sound of DSD 5.1ch input HDMI IN 3, output from the speaker.
1-9. VIDEO FUNCTION CHECK
See "OPERATION CHECK-3, -6" for TEST MODE operation.
a. Confirm Video output signal as shown Table 2, while Video signal are input as shown Table 1.
NOTE: Confirm the HDMI path at 1080p signal.
Table 1
Input
Composite Video
BD/DVD
A
VCR/DVR
B
CBL/SAT
C
GAME
D
PC
H
AUX
E
Table 2
Composite Video
ZVCR out
Test mode
A
5-05(BD/DVD)
5-06(VCR/DVR)
---
C
5-07(CBL/SAT)
D
5-08(GAME)
H
5-09(PC)
E
5-10(AUX)
b. OPERATIONS OF VIDEO SIGNAL-DETECTION
Set the TEST MODE to "TEST-5-00".
Confirm that "RDS" of FL TUBE lights, when the component video signal is input.
1-10. MISCELLANEOUS
See "OPERATION CHECK-3" for TEST MODE operation.
a. Please confirm LED and FL displaying by the FL test mode. And confirm the destination setting. ---> See to"OPERATION CHECK-3".
b. Confirm Key Operation.
Change the state to KEY TEST under TEST MODE described in Section 4-2. to confirm each key operation.
c. Confirm the version of each firmware.--->See to" SERVICE PROCEDURE-2".
d. Confirm the firmware combination check.
e. Confirm the DSP flash check.(Except TX-NR414, HT-R758 )
When it is normal, FL display indicate "A:OK B:OK"
TX-SR313/ NR414/ HT-R391/358/558/591/758/ RC430/440
Component
HDMI
IN1
F
IN1
---
No
IN2
IN2
G
IN3
---
No
IN4
---
No
IN5
---
No
IN6
Component
HDMI
OUT
OUT
Monitor out
F
J
A
B
---
K
G
L
C
---
M
D
---
N
H
---
O
E
J
K
L
M
N
O
Advertisement
Table of Contents
