Motorola DCT5100 Setup Manual page 8

Connecting the DCT5100 to a High-Definition TV and VCR
TO
TV/VCR
Cable/
Antenna IN
Cable/
Antenna OUT
Cable/
Antenna IN
1. Using the Video Only diagram, connect your coaxial cable to the Motorola DCT5100 and the DCT5100 Y Pb Pr HD video connection directly to
This diagram should be
used if you intend to use
a standard stereo VCR in
your configuration. This
configuration will allow
you to watch both HD
2. Connect the single connector end of a Y audio splitter cable to the AUDIO OUT R (red) on the DCT5100. Insert the other ends into the AUDIO IN R
and Standard Definition
video on your HDTV as
3. Use the second splitter cable to connect the AUDIO OUT L (white) on the DCT5100 to the AUDIO IN L connections on both the VCR and the HDTV.
well as record and play
4. Use the two-pronged RCA cable to connect the AUDIO OUT L & R on your VCR to the AUDIO IN L & R on your HDTV.
Standard Definition video
5. Using an S-video cable, connect the S-VIDEO output on the DCT5100 to the S-VIDEO IN on your VCR. Then use the second S-video cable to connect
via your VCR.
– OR –
6. Using your single-pronged RCA type video connector cable, connect the VIDEO OUT (yellow) connector on the DCT5100 to the VIDEO IN connector
IR
CABLE
USB
IN
Audio IN
Video IN
R L
Audio OUT Video OUT
R L
Video 1 Video 2
S-Video
Video
R R
Audio
L L
your HDTV.
Connector Cables to be used: • 1 set of two-pronged RCA type audio cables (red & white)
• 2 S-video cables – OR – 2 sets of single-pronged RCA type video cables (yellow)
Note: The video cables you use will depend on the inputs/outputs on your VCR and HDTV. S-video is considered the higher standard definition video output
and should be your first choice.
on your VCR and AUDIO IN R on your HDTV.
the S-VIDEO output on the VCR to the S-VIDEO IN on your HDTV.
on your VCR. Next, use the second single-pronged RCA type video connector cable to connect the VIDEO OUT connector on your VCR to the VIDEO
IN connector on your HDTV.
AUDIO IN VIDEO
R L SPDIF IN OUT
HPNA
S-VIDEO
TV
Pass Card
R L
Y Pb Pr
AUDIO
OUT
VCR
S-Video IN
S-Video OUT
HDTV
Video 3
Y
Pb
Pr
R
L
DCT5100
IEEE 1394
SWITCHED
105/125V
60Hz
4A MAX
CONVENIENCE
500W MAX
OPTICAL
OUTLET
SPDIF
Do not plug the DCT5100 power cord into a wall
outlet until you have completed all connections
between the DCT and other components.
• 2 sets of "Y" audio splitter cables