User Programmable Run Time / Run Time Extension; Remote Start Safety Features; Transmitter Button Functions - Code Alarm CA 5051MT Owner's Manual

User Programmable Run Time / Run Time Extension

The system has the ability to allow the user to extend the time the vehicle will be
running under control of the remote start. This will only extend the run time back to
the current run time setting during the current remote start cycle. If your system is
set to run 15 minutes and the time remaining is 4 minutes, extending the run time
will reset the countdown timer to 15 minutes and your vehicle will continue to run
for another 15 minutes. Follow the steps below to extend the vehicle's run time.
1. The remote start must already be active.
2. Press and release the
3. The system will chirp to confirm that the run time has been reset.

Remote Start Safety Features

For safety and security reasons, the system will shutdown or prevent the remote
vehicle starter from activating if any of the following occur:
1. The vehicle hood is open.
2. The brake pedal is pressed prior to turning the ignition key to the ON
position.
3. The engine is over-reved (tach checking only).
4. Valet mode is active.

Transmitter Button Functions

1 Way
Transmitter
Lock
Unlock
Trunk
Car Finder
Panic
Remote Start
Remote Start
Shut Down
Run Time
Extention
6
button 4 times.
Car Find /
Lock Unlock
Panic
X
X
X
Start Operation Method
Press and Release
Press and Release
Push and Hold (3 Sec)
X Press and Release
X Push and Hold (3 Sec)
Press and Release (1 or 2 times
X
depending on selectable option)
X Push and Hold (3 Sec)
X Press and Release 4 times.
2010 Audiovox Electronics Corporation. All rights reserved.