Preheating Or Precooling The Vehicle's Interior; User Programmable Run Time / Run Time Extension; Operating The Daily Start Timer - Code Alarm CA 5055 Owner's Manual

Preheating or Precooling the Vehicle's interior

Before exiting the vehicle, set the temperature controls to the desired setting and
operation. After the system starts the vehicle, the heater or air conditioner will
activate and heat or cool the vehicle's interior to your setting.

User Programmable Run Time / Run Time Extension

The system has the ability to allow the user to extend the time the vehicle will be
running under control of the remote start. This will only extend the run time back to
the current run time setting during the current remote start cycle. If your system is
set to run 15 minutes and the time remaining is 4 minutes, extending the run time
will reset the countdown timer to 15 minutes and your vehicle will continue to run for
another 15 minutes. Follow the steps below to extend the vehicle's run time.
1. The remote start must already be active.
2. Press and release the
3. The system will chirp 1 time and flash the parking lights 4 times to
confirm that the run time has been reset.

Operating the Daily Start Timer

The system has the ability to start your vehicle based on a 24-hour countdown timer.
This feature requires a two-part activation sequence. From the remote, while in range
of the vehicle, pressing both the
countdown timer (the vehicle will start 24 hours from this time). Next, When you are
finished operating the vehicle for the day, perform the following steps to complete the
process.
1. Turn the ignition ON/OFF (vehicle must be disarmed).
2. Within 10 seconds, while pressing the brake, press and release the
button twice.
3. The vehicle will emit 2 chirps and flash the parking lights 4 times.
6
button 4 times.
& buttons together will activate the 24 hour
ca5055 Owners revA